Link Search Menu Expand Document

Connect Seeker to QGC

Table of contents

  1. Edit voxl-vision-px4.conf
  2. Restart the voxl-vision-px4 Service
  3. Confirm Connection with QGroundControl

Edit voxl-vision-px4.conf

VOXL needs to know the IP address of your computer running qGroundControl. This is set in the ‘qgc_ip’ field of the /etc/modalai/voxl-vision-px4.conf file on VOXL. This will inform the voxl-vision-px4 systemd service to send MAVLink data to our computer.

Run the following command and update the qgc_ip field to match your computer’s IP.

yocto:/home/root# vi /etc/modalai/voxl-vision-px4.conf

voxl-vi-cmd-line.png

Hit i to enter edit mode, use arrow keys to navigate to the qgc_ip field and edit there. To save, hit esc then :wq to write and quit.

voxl-vi-edit.png

If you put VOXL on your own WiFi or LTE network you will have to do the same procedure.

For more information on this config file and the options available see the VOXL Vision PX4 manual.

Restart the voxl-vision-px4 Service

To reset the voxl-vision-px4 service and reload the configuration, run the following command:

yocto:/home/root# systemctl restart voxl-vision-px4

Note this will also reset the Visual Inertial Odometry (VIO) algorithm and reset VIO’s origin to wherever the drone is when you reset the service.

Confirm Connection with QGroundControl

After the previous step is completed, the vehicle should automatically connect to QGroundControl

voxl-qgc-connected.png


Next Step: RC Settings



Copyright © 2019-2022 ModalAI Inc.